In short
If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Livingston realigns or replaces the sensors and tests the safety reverse.

Doors that won't close in Livingston
Livingston has a lot of teardowns and new construction, and new garages bring their own sensor problems: wire stapled too tightly behind drywall, sensors mounted before the floor was finished, and three or four doors wired close together. In the older houses around Burnet Hill and Riker Hill, the original single-car garages are narrow and the sensors sit where tires and bins hit them. If one door in a row of new ones keeps reversing, the wiring is the first thing a technician checks.
What it means when the door won't go down
Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.
- Blinking sensor light: the eyes are out of line or one lens is dirty.
- Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
- Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.
What you can safely try yourself
Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.
Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.
How the repair is done
The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.
Around Livingston
- Collins: Central neighborhoods near the town center.
- Harrison: Northern section toward Roseland.
See the full Livingston service area.